11/7/2023 0 Comments Christmas windowblindI am completely in love with how this upcycling project came out, and even I can't believe I made these modern trees out of broken window blinds.You will receive your order either via our Direct Delivery Service or an Independent Shipping Agents. I decided to leave them white to look like snow, and I topped them each with a glittery gold star. I decided not to use any sort of glue to hold the slats in place because it is more fun this way and would also be easier to flatten and store after Christmas. It looked so great that I made two more smaller ones, to create a decorative trio. I couldn't believe how great it looked from this simple stacking technique. I continued with the sets of slats, and as they got shorter and shorter, my tree really started to take shape. Once again, I spread them out evenly, starting right after the last one from the first row. Then I grabbed the second longest set of slats and slid them down onto the pole. Then I fanned the slats out into a circle, spreading them so they were spaced pretty evenly. I started with my longest set of slats, and slipped them right down over the pole and let them rest on the pipe trunk. With that, all the pieces were ready to assemble! Using the measurement I made earlier of all the slats stacked up, I cut the length of the wand accordingly, measuring from the top of the pipe and leaving an extra inch at the end for adding a topper later. The pipe also serves to keep the bottom row of slats suspended for a more natural tree trunk look. I slipped a pipe piece over the wand and filled it with hot glue, creating a nice solid tree trunk that was firmly attached to the base block. To build the base, I drilled a half-deep hold in the block and filled it with a puddle of hot glue, then stuck the end of the wand into that. I grabbed the original wands that came with the blinds and some pieces of PVC pipe that I cut to 2" long. I started with some leftover scraps of PVC trim I had on hand (though painted wood would have worked just fine). I repeated this for each set of six slats, until everything had a hole in it. Then I grabbed a set of six slats and used my drill and a 1/2" bit to make a hole in the middle, drilling right through all six of them at the same time. The smallest set was as long as the slats were wide (so, square) and the longest set was as long as I could get them within the limits of the slat length.Īt this point, I took a minute to measure the height of all the slats stacked up, which is a measurement I would need later when building the base. I kept going with more sets of six, cutting each set to 1/2" shorter or longer than the set before or after it. I cut six more slats 1/2" longer than the first set, and then another six 1/2" longer than that. Then I stacked six pieces together and cut them to the same length. Since the slats have holes in them from the strings, I started by cutting those portions away and getting down to solid pieces I could work with. These were faux wood blinds, made of plastic, with each slat about 2" wide. I started by removing all the strings from the blinds and separating them. How to upcycle broken blinds into mini Christmas trees If you prefer step-by-step instructions, keep reading to see exactly how I turned these faux wood window blinds into something special. If you can't see the video, try viewing it directly on YouTube.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |